UPA-USB Programmer Script - Automotive Software Utility 1.3

Works with: UPA-USB hardware programmer (ELRASOFT) — Windows software for Read / Write / Verify memory chips and supported MCUs, using included scripts.

Supported devices (full list):

• I2C EEPROM (24Cxx/24LCxx): 24C01, 24C02, 24C04, 24C08, 24C16, 24C32, 24C128
• SPI EEPROM (25xxx): 25080, 25128, 25201, 25202, 25320
• Microwire EEPROM (93Cxx): 93C46, 93C56, 93C66, 93C76, 93C86, 93CS56
• SPI EEPROM (95xxx): 95020, 95040...

Click to expand...

amelio said:

gracias

Click to expand...

binunlock.com

jfp said:

can UPA-USB sеriаl Programmer run on Windows 7 ?

Click to expand...

• Works best on Windows XP / 7 (32-bit) — this is the recommended environment.
• On Windows 7/10 64-bit it can also work, but you may need to install the USB drivers manually and in some cases run the software in compatibility mode (right-click → Properties → Compatibility → Windows XP SP3).
• Make sure you install the correct FTDI USB drivers for the UPA-USB hardware so the device is properly recognized in Device Manager.

• Check Device Manager for an unknown device or driver error under "USB Controllers" or "Ports (COM & LPT)".
• Reinstall the FTDI driver manually.
• Try a different USB port (preferably a rear port directly on the motherboard, not a hub).
• Disable UAC and run the software as Administrator.

Gemini said:

Yes, the UPA-USB sеriаl Programmer (ELRASOFT software) runs on Windows 7 without issues. It's actually one of the most compatible OS versions for this tool.

A few notes:

• Works best on Windows XP / 7 (32-bit) — this is the recommended environment.
• On Windows 7/10 64-bit it can also work, but you may need to install the USB drivers manually and in some cases run the software in compatibility mode (right-click → Properties → Compatibility → Windows XP SP3).
• Make sure you install the correct FTDI USB drivers for the UPA-USB hardware so the device is properly recognized in Device Manager.

If the device is not detected:

• Check Device Manager for an unknown device or driver error under "USB Controllers" or "Ports (COM & LPT)".
• Reinstall the FTDI driver manually.
• Try a different USB port (preferably a rear port directly on the motherboard, not a hub).
• Disable UAC and run the software as Administrator.

For the smoothest experience, many technicians keep a dedicated Windows XP or Windows 7 32-bit machine (or a virtual machine) specifically for older programmers like the UPA-USB.

Click to expand...

D-MASS said:

Useful script

Click to expand...

• The UPA-USB main unit
• Full set of adapters (SOIC-8 clip, EEPROM adapters, MCU adapters)
• USB cable

• UPA-S uses its own software and script format
• The communication protocol and device handling differ